Powder coatings for architecture

Product use

---building aluminum profiles, transportation facilities, sports facilities, garden facilities, etc.

Conditions of use

---high voltage electrostatic spraying or friction - coated products

---coating thickness: in the use of 40-100 microns, the proposed film thickness of 60-80 microns

---average coverage: 10-12 square meters / kg, film thickness of 60-80 microns (to 100% usage)

---curing conditions: recommended 200 degrees 10 minutes

Physical property
---specific gravity: 1.5-1.8g/cm3 (due to different formulations and colors)
---particle size distribution: the use of different types and different standards for the average particle size of 35-40 microns, less than 10 micron powder <10%, greater than 90 microns powder <0.5%

Film properties ---all tests were performed using 0.8mm cold rolled steel plate in thick oil and rust, the film thickness of 50-80 microns

Product packaging
---carton packing, lined with single layer thick film polyvinyl chloride plastic bag, net weight 20kg or 25kg per carton

Storage condition
---the product should be stored in a dry, ventilated room at 35 degrees C, while avoiding direct sunlight. As in the air conditioning room storage, before use to powder at room temperature or with the same spraying equipment (temperature) storage, avoid damp. Under the above conditions, the powder can be stored stably for 12 months.
Note: for low temperature curing type and gloss in 40% (60 degrees) below the powder, storage temperature is less than 30°C

Health and safety
---product raw material does not contain toxic substances, are in line with RoHS and reach, the baking free of toxic gases produced, but it should be avoided in the use of inhalation of dust in the process, the operator should wear a dust mask, and minimize the long-term exposure of skin and powder coating, attached to the skin of paint, can be washed with soap.